Furman Power M-8S 15A Standard Power Conditioner with Sequencer M8S

Description

YOUR BEST SOURCE FOR PRO AUDIO GEAR
Free shipping
on Domestic orders
*
30-day returns
moneyback guarantee
Customer Support
Online Chat
Furman Power M-8S 15A Standard Power Conditioner with Sequencer M8S
Description
Furman Power M-8S 15A Standard Power Conditioner with Sequencer M8S
Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load. Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system where power sequencing is desired. Install an M-8s in to the top slot of your rack, and the six delayed outlets in the rear panel will power up sequentially and protect all your equipment up to a 15-amp load. Includes 3 delayed outlet banks - each with 2 outlets - plus 2 unswitched outlets.
Features
Power Sequencing
Prevents excessive inrush currents.
Six sequenced rear panel outlets (in three groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only).
Noise Filtration
Noise filtering to reduce radio frequency and electromagnetic interference.
Surge Protection
Ensures equipment stays safe.
9 Total Outlets
Eight rear panel outlets and one front panel convenience panel outlet.
15 Amp Rating
15 amp rating, with circuit breaker.
"Protection OK" Indicator
Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.
Wall Wart SpacingAll settings and configurations available on rear panel.
Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.
Specifications
General
Family: Merit Series
Line Voltage: 120 (Volts)
BlueBOLT Enabled: No
AC Protection
Automatic Voltage Shutoff: No
Shipping Info
Length: 21.9 (Inches)
Width: 9.4 (Inches)
Height: 3.4 (Inches)
Weight: 7.65 (Lbs)
Unit of Measure: Each
Master Pack Qty: 6
Other Specifications
Maximum AC Current Rating: 15 Amps, 120 VAC (Thermal breaker)
AC Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
Convenience Outlet (Front Panel): 1 Un-switched NEMA 15-5R
Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex)
6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
AC Surge Protection: Merit Class (sacrificial)
Spike Protection Mode: Line to neutral, zero ground leakage
Max Continuous Operating Voltage: 130V RMS
Max Clamp Voltage: 500 Volts Peak
Peak Impulse Current: 12,000 Amps
Energy Rating (2 X 820µS): 225 Joules
AC Filtering: Pi LCR Filter
Noise Attenuation: >26dB, 100 Khz to 1 MHz
Operating Temperature Range: 5C (40F) to 40C (105F) degrees
Humidity Range: <90% rH (Relative Humidity)
Rocker Switch: Front panel, Sequence (ON, OFF)
Thermal Circuit Breaker: Front panel, push to reset
Front panel indicators: Delay 1, Delay 2, Delay 3, Power, Protection OK
Control/Status/Triggering (Rear Panel: Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained
Potentiometer: Rear panel, time calibration fine tune delay adjust
Remote Terminal: +5-30VDC In, 12VDC (12mA) Out
Remote Terminal: Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
Size: 1.75" X 19.00" X 6.5" (HWD) – ANSI 1RU
Mass: 5.3 lbs.
Power Consumption (No Load): 5 Watts
Safety Agency: C/CSA/US
*We only offer free shipping to the lower 48 contiguous states. AK, HI, APO, FPO and US Protectorates (PR, VI and American Samoa) addresses will incur additional shipping charges. Please contact us for a shipping quote. These shipments will only be shipped via Priority Mail. There are some instances that free shipping will be offered if they are smaller and lighter items.