Furman M-8x2 15 Amp Power Conditioner + SKB 1SKB19-R1208 12U x 8U Gig Rig

Description

ProAudioStar
DJ GEAR
INSTRUMENT GEAR
LIVE SOUND
RECORDING
MICROPHONES
HEADPHONES
ACCESSORIES
SOFTWARE
LIGHTING
BUNDLES
Authorized Dealer - Full Warranty
Furman M-8x2 + SKB 1SKB19-R1208
15 Amp Power Conditioner with 12U x 8U Gig Rig
- Bundle Deal -
Description
Package Includes :
1 x
Furman M-8x2
1 x
SKB 1SKB19-R1208
Furman M-8X2
Install an M-8x2 in to the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load.
A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. The M-8x2 is designed for applications where lights are not required.
Instrument Rigs
You've got a rack for your effects, preamps, tuner...You're going to plug that into the wall? One big spike and your rig is up in smoke. Furman's standard level surge/spike protection defends your gear from the spikes and surges that are so common at gigs and practice spots. With Furman's standard level RFI/EMI filtration, you'll get a quieter tone without pops, crackles, and the local radio station coming out of your amp.
Recording
Can't track down where that noise is coming from? Your mix sounding flat? With Furman's standard level RFI/EMI filtration you'll lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman's standard level surge and spike protection keeps your sensitive digital equipment from acting funny or burning up due to everyday spikes and surges. With a 15A capacity and nine total outlets, it's enough to power your whole home studio.
Dj Equipment
Bars, clubs and other event venues have some of the worst power out there - from air compressors turning on and off to light shows pulling current loads up and down, the AC power can be a strain on the circuits in your rig. Furman's standard level protection and filtration keeps the bad stuff out.
Pro Audio
When you're out there gigging, you never know what kind of power you're going to get. The wear and tear on mobile rigs eventually takes it toll - that's why it's smart to plug into Furman's standard level protection and RFI/EMI filtration. It keeps your equipment safe and sounding clean. Whether you're setting up a show at the local club or powering up the church band for their next service, make sure you give them power they can trust.
SKB 1SKB19-R1208
The SKB Gig Rig series has set the standard for mixer/rack cases for more than 15 years. The 4th Generation Gig Rig raises the bar yet again. Based on the 1SKB19-R1406 Mighty Gig Rig design, the 1SKB19-R1208 Gig Rig provides more versatility than previous generation Gig Rigs.
Roto-molded of Linear Low Density Polyethylene (LLDPE), the 1SKB19-R1208 Gig Rig has a uni-body construction that is extremely durable. The 7° angled top steel rails are 12U rack spaces with extra room in the back for cable connections. The lid provides enough space for cables to stay connected as well as, space for the optional 1SKB-AV8 retractable shelf. The front facing 8U steel rails provide enough space for amps or outboard gear.
In the same fashion as the Mighty Gig Rig, the lid can also be used as a pedestal for the 1SKB19-R1208 Gig Rig. By placing the lid on the bottom wheeled skid and locking down the Gig Rig on top, the mixer height has perfect performance position. The 1SKB-R1208 Gig Rig includes two injection molded extra-long handles, (one per side) for easy lifting in transport. Four heavy-duty locking castors complete the Gig Rig.
Features/Specs
Furman M-8x2
Noise Filtration
AC noise filtering to reduce radio frequency and electromagnetic interference (RFI/EMI)
Surge Protection
Spike & surge protection ensures equipment stays safe and your power stays clean
9 Total Outlets
8 rear panel outlets and 1 front panel outlet
15 Amp Rating
15 amp rating, with circuit breaker
"Protection OK" Indicator
Front panel indicator LED lets you know that your equipment is being protected
Wall Wart Spacing Indicator
Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters
General
Family : Merit Series
Line Voltage : 120 (Volts)
Number of Outlets : 9
Number of Isolated Banks : 0
Outlet Descriptions : All 9 outlets filtered and surge protected
Rack Mountable : Yes
Rack Ears Included : Yes
Front Panel Meter(s) : No
Front Media Light(s) : No
ControlFront panel : - On/Off switch
Voltage Regulation : No
Compliance : cTUVus
USB Charging : N/A
Low VoltageTrigger : N/A
AC Power Cord : 6 ft. captive, 14 AWG, with 3-conductor Edison Plug
Dimensions : 19" W x 3.75" D x 1.75" H
AC Protection
AC Protection Technology : Standard spike and surge protection
Under-Voltage Shutoff : N/A
Over-Voltage Shutoff : 130 VAC
Maximum Current Rating : 15 (Amps)
Filtration
Filtration Technology : Standard Level RFI/EMI Filtration
Filtration Rating : Greater than 23dB, 200Khz to 10 Mhz
Signal Line Protection : No
Shipping Info
Length : 2.19 (Inches)
Width : 6.8 (Inches)
Height : 3 (Inches)
Unit of Measure : Each
UPC : 654061028307
Master Pack Qty : 6
Other Specifications
Spike Protection Modes : Line to Neutral
Energy Dissipation : 150 joules
Peak Impulse Current : 12,000 amps
Construction : Steel Chassis, Black Painted
SKB 1SKB19-R1208
Accommodates deep mixers
Greater Vertical mixer depth
Accommodates the AV-8 retractable shelf
Indestructible injection molded side handles
Locking twist latches
Will stack with the 1SKB-R1906 for additional rack units
Interior Width : 19.00 in 48.26 cm
Exterior Depth : 27.50 in 69.85 cm
Exterior Width : 23.50 in 59.69 cm
Exterior Height : 29.50 in 74.93 cm
Rack Space Units Total : 28 28
Rack Space Units Top : 12 12
Rack Space Units Bottom : 16 16
Rack Depth Rail to Rail : 19.00 in 48.26 cm
Rack Depth Front Rail to Back Lid : 22.25 in 56.52 cm
We are authorized dealers for all these brands. Click a logo to see our listings.
ProAudioStar is also not responsible for any taxes, local duties, or fees outside of the USA and those are not included in the sale price or ship charge.
If an item is refused by the buyer, ship costs to and from the destination in which the item was shipped to are not refunded. Please note the cost of return shipping is usually double of what the original ship cost.
Shipping is not free to HI, AK, and PR. FREE SHIPPING ONLY TO THE LOWER 48 STATES.
We provide free shipping to the contiguous 48 United States, on most items.
Shipping fees to ALL OTHER LOCATIONS will be calculated individually and added to customer invoices. ProAudioStar is also not responsible for any taxes, local duties, or fees outside of the USA and those are not included in the sale price or ship charge. In the event that the customer refuses a shipment, all shipping costs to and from the country or State in which the item was shipped to are not refunded. Please note, in some cases return shipping can cost as much as double the original ship cost.
We operate a 30-day return period. Items must be returned with all original packaging as well as all included items. Items that are not returned in original, resalable condition are subject to a 15% restocking fee. We charge a 15% restocking fee on returned items only if the item is clearly used and or the packaging is tarnished. A 10% re-stock is more likely if the unit comes back in mint condition. The ship cost we paid to ship your item will be deducted as well. In some cases restock fees and ship costs can be applied as a store credit.
We will exchange a defective unit for the same unit within the 30-day period. After that period, you will have to work directly with the manufacturer for warranty service.
Items that can not be returned include: software, units with contents or packaging that is damaged/missing, and items that are considered for personal use (such as earphones, headphones, microphones, instrument mouthpieces, harmonicas or other items that you wouldn't want to purchase if someone else had previously used them). Also, Items which we do not normally stock (i.e. "Special Orders", discontinued products, close-outs, used products, etc.) are non-returnable. We strongly suggest that you check your order after receiving it to be sure that it is in proper working order.
Please contact us for a Return Authorization before returning any items.