4x4x4 Blue LED Cube Kit

Description

DIY LED Cube 4x4x4
Amazing 3D display with endless possibilities. Build an amazing 3D LED display.
Difficulty
: Intermediate-Advanced
Time Required
: 6 hours
Knowledge Required
: Basic electronics and soldering skills, AVR microcontroller programming skills.
64 LEDs makes up this 4x4x4 cube, controlled by an Atmel Atmega16 microcontroller. Each LED can be addressed individually in the software, enabling it to display amazing 3D animations!
Visit the Jameco Workshop page for step-by-step instructions.
Kit Includes
(1) Prototyping Board PN 206594
(1) Atmel AVR Atmega 16 Microcontroller- 323133
(64) Blue Diffused 3mm LEDs PN 333383
(18) 220 Ohm Resistors PN 690700
(1) Red LED PN 333973
(1) Green LED PN 34761
(1) 10k Ohm Resistor PN 691104
(4) 2.2k Ohm Resistor PN 690945
(4) BC337 Transistors PN 254810
(3) 0.1uF Capacitor PN 544921
(2) 22pF Capacitor PN 15405
(1) 14.7456MHz Crystal PN 537799
(2) SPST Buttons PN 155380
(1) 40 Pin IC Socket PN 112311
(1) 10 Pin Header PN 67812
(1) ISP Programmer PN 2136788
(1) USB Cable PN 222010
(1) Hookup Wire PN 2152884
(1) Coin Cell Battery PN 2123784
Optional Materials:
(1) 10uF Capacitor PN 29891
(1) 1000uF Capacitor PN 330722
(1) 7805T Transistor- 51262
(1) Battery Clip PN 11280
(1) 9V Battery PN 198731
Suggested Tools list:
Wire Cutters PN 35482
Pliers PN 177608
63/37 Solder PN 151474
Solder Flux PN 2094258
Solder Wick PN 41082
25W Soldering Iron PN 129040
Soldering Stand PN 36329
Sponge PN 134631
LED Tester PN 2236421
Used to build optional circuit that will supply 5V of power with a 9V source.